Subject	it might be random,
Posted by	youngbloodz on June 28, 2011 at 2:14 PM
	This message has been viewed 166 times.
In Reply To	Anyone else have a failed Z1 shifter? posted by ZXoltan on June 28, 2011 at 01:25 PM
Message	I haven't heard of anyone else with this issue. Honestly I still like the shifter, even wit this issue I lime having the bearing instead of a bushing. I would do it again if I could go back, its not guaranteed to happen to everyone, it gets pretty hot in Nc and I drive my z everyday. Even if it does happen to someone, they push in the clutch, pull over, and put the two halves back together, you don't have to remove anything, you can do it all by feel, it just takes a minute. I have pics but I never bothered to figure out how to post on tt.net.
Follow Ups	My recent mishap with Z1 turned positive. - youngbloodz 13:17:13 06/28/11 Anyone else have a failed Z1 shifter? - ZXoltan 13:25:47 06/28/11 it might be random, - youngbloodz 14:14:23 06/28/11 Definitley not common or inevitable. - Russell@Z1 14:28:19 06/28/11 Is there a way of knowing if I have the revised version? (n/m) - KevinZtwin 04:26:43 06/30/11 Did you take any pictures? (n/m) - Wright (Ca) 13:42:25 06/28/11 I had the rubber fail as well. Not fond of that design... - puddlejumpinzx 15:21:06 06/28/11 good to hear you have such low standards (n/m) - LJZTT 15:40:30 06/28/11 youngbloodz should get together with LEADZX below to endorse - 240Z FeO2 00:59:35 06/29/11 maybe if i got sponsored by z1 lol, - youngbloodz 07:32:07 06/29/11 yeah totally "lol" - LJZTT 21:02:50 06/29/11 Mine popped off almost instantly... - L£AÐZX 19:27:58 06/28/11
Post a Followup	You cannot reply to this message because you are not logged in.