Subject	Re: Anyone Using A Snow Performance Safe Injection Module?
Posted by	rhombicblue on June 27, 2011 at 9:33 AM
	This message has been viewed 226 times.
In Reply To	Anyone Using A Snow Performance Safe Injection Module? posted by rhombicblue on June 26, 2011 at 10:33 PM
Message	Guys, thanks for the advice, but one question? The basic suggestion was to cut power to the EBC solenoid. Is the EBC solenoid the same thing as the stepper motor module? I did implement your recommended solution by using a relay to cut power to my HKSVI boost controller, but the boost level remainded at ~ 20 PSI even when power was cut.
Follow Ups	Anyone Using A Snow Performance Safe Injection Module? - rhombicblue 22:33:42 06/26/11 Don't you just wire the EBC to the module? - Crazy Greek 23:05:19 06/26/11 Nope. You need a relay in between. - MixManMash 00:20:59 06/27/11 Ah that's right. Thanks for correcting me. - Crazy Greek 00:50:56 06/27/11 Just it hook it up to a super bright led positioned dead - ztunerz 00:31:32 06/27/11 I just wired mine up last weekend... - Madhatter10-6 07:28:10 06/27/11 I wouldn't pay the $20 that snow is asking when basically - MixManMash 08:05:33 06/27/11 agreed... - Madhatter10-6 08:20:34 06/27/11 Re: Anyone Using A Snow Performance Safe Injection Module? - rhombicblue 09:33:06 06/27/11 Re: - Madhatter10-6 09:53:16 06/27/11 Are you pushing 20psi out of Sport 500's on pump fuel? - JMW300ZX 10:22:00 06/27/11 Re: Are you pushing 20psi out of Sport 500's on pump fuel? - rhombicblue 13:13:37 06/27/11 Just checked it out, very nice numbers. - JMW300ZX 13:21:10 06/27/11 Re: Just checked it out, very nice numbers. - rhombicblue 13:30:39 06/27/11 re - Madhatter10-6 14:40:07 06/27/11 On my subaru, I use the +12V to energize the coil on - zgene4 22:14:27 06/27/11
Post a Followup	You cannot reply to this message because you are not logged in.