Subject	Nope. You need a relay in between.
Posted by	MixManMash on June 27, 2011 at 12:20 AM
	This message has been viewed 187 times.
In Reply To	Don't you just wire the EBC to the module? posted by Crazy Greek on June 26, 2011 at 11:05 PM
Message	Wire one end of the coil to the safe injection output and the other end to ground. Take one of the wires going to the EBC solenoid and wire it through a normally closed contact of the relay.
Follow Ups	Anyone Using A Snow Performance Safe Injection Module? - rhombicblue 22:33:42 06/26/11 Don't you just wire the EBC to the module? - Crazy Greek 23:05:19 06/26/11 Nope. You need a relay in between. - MixManMash 00:20:59 06/27/11 Ah that's right. Thanks for correcting me. - Crazy Greek 00:50:56 06/27/11 Just it hook it up to a super bright led positioned dead - ztunerz 00:31:32 06/27/11 I just wired mine up last weekend... - Madhatter10-6 07:28:10 06/27/11 I wouldn't pay the $20 that snow is asking when basically - MixManMash 08:05:33 06/27/11 agreed... - Madhatter10-6 08:20:34 06/27/11 Re: Anyone Using A Snow Performance Safe Injection Module? - rhombicblue 09:33:06 06/27/11 Re: - Madhatter10-6 09:53:16 06/27/11 Are you pushing 20psi out of Sport 500's on pump fuel? - JMW300ZX 10:22:00 06/27/11 Re: Are you pushing 20psi out of Sport 500's on pump fuel? - rhombicblue 13:13:37 06/27/11 Just checked it out, very nice numbers. - JMW300ZX 13:21:10 06/27/11 Re: Just checked it out, very nice numbers. - rhombicblue 13:30:39 06/27/11 re - Madhatter10-6 14:40:07 06/27/11 On my subaru, I use the +12V to energize the coil on - zgene4 22:14:27 06/27/11
Post a Followup	You cannot reply to this message because you are not logged in.