Subject	Anyone Using A Snow Performance Safe Injection Module?
Posted by	rhombicblue on June 26, 2011 at 10:33 PM
	This message has been viewed 215 times.
Message	For those of you not familiar with the subject module, it monitors water/meth flow rate from the water/meth pump discharge. If the flow rate is below a preset value, the module generates a +12 VDC discrete which can be used to reduce current boost pressure to a safe level (typically, the pressure at which the wastegates begin to open). The problem is that I can't think of a good way to implement this safing feature using relays, solenoids, etc. Anyone have a good idea?
Follow Ups	Anyone Using A Snow Performance Safe Injection Module? - rhombicblue 22:33:42 06/26/11 Don't you just wire the EBC to the module? - Crazy Greek 23:05:19 06/26/11 Nope. You need a relay in between. - MixManMash 00:20:59 06/27/11 Ah that's right. Thanks for correcting me. - Crazy Greek 00:50:56 06/27/11 Just it hook it up to a super bright led positioned dead - ztunerz 00:31:32 06/27/11 I just wired mine up last weekend... - Madhatter10-6 07:28:10 06/27/11 I wouldn't pay the $20 that snow is asking when basically - MixManMash 08:05:33 06/27/11 agreed... - Madhatter10-6 08:20:34 06/27/11 Re: Anyone Using A Snow Performance Safe Injection Module? - rhombicblue 09:33:06 06/27/11 Re: - Madhatter10-6 09:53:16 06/27/11 Are you pushing 20psi out of Sport 500's on pump fuel? - JMW300ZX 10:22:00 06/27/11 Re: Are you pushing 20psi out of Sport 500's on pump fuel? - rhombicblue 13:13:37 06/27/11 Just checked it out, very nice numbers. - JMW300ZX 13:21:10 06/27/11 Re: Just checked it out, very nice numbers. - rhombicblue 13:30:39 06/27/11 re - Madhatter10-6 14:40:07 06/27/11 On my subaru, I use the +12V to energize the coil on - zgene4 22:14:27 06/27/11
Post a Followup	You cannot reply to this message because you are not logged in.