Subject	What about for a built long block that's been sitting for
Posted by	JUNz (?00)rwhp on June 23, 2011 at 3:35 PM
	This message has been viewed 162 times.
In Reply To	What do I need refresh before I drop the motor in? posted by VoslickZ on June 23, 2011 at 12:03 PM
Message	over 12yrs garage kept in california. Do I also hand turn the motor? I was advised to remove the spark plugs and spray a good amount of WD-40 into each cylinder before hand turning the motor?
Follow Ups	What do I need refresh before I drop the motor in? - VoslickZ 12:03:39 06/23/11 If it was inside/garged you likely dont need to do anything (n/m) - Bernie (NoVA) 12:31:12 06/23/11 It was inside, and was covered in the plastic wrap. (n/m) - VoslickZ 12:56:17 06/23/11 Speak a. Kyle @ IPP but aside from turning it over by hand - Bernie (NoVA) 12:58:16 06/23/11 What about for a built long block that's been sitting for - JUNz (?00)rwhp 15:35:24 06/23/11 I'd use ATF in the cylinders to free the rings (n/m) - boileralum 14:54:10 06/25/11
Post a Followup	You cannot reply to this message because you are not logged in.