Subject	It was inside, and was covered in the plastic wrap. (n/m)
Posted by	VoslickZ on June 23, 2011 at 12:56 PM
	This message has been viewed 123 times.
In Reply To	If it was inside/garged you likely dont need to do anything (n/m) posted by Bernie (NoVA) on June 23, 2011 at 12:31 PM
Message
Follow Ups	What do I need refresh before I drop the motor in? - VoslickZ 12:03:39 06/23/11 If it was inside/garged you likely dont need to do anything (n/m) - Bernie (NoVA) 12:31:12 06/23/11 It was inside, and was covered in the plastic wrap. (n/m) - VoslickZ 12:56:17 06/23/11 Speak a. Kyle @ IPP but aside from turning it over by hand - Bernie (NoVA) 12:58:16 06/23/11 What about for a built long block that's been sitting for - JUNz (?00)rwhp 15:35:24 06/23/11 I'd use ATF in the cylinders to free the rings (n/m) - boileralum 14:54:10 06/25/11
Post a Followup	You cannot reply to this message because you are not logged in.