Subject	Should be ~28mm I.D. (n/m)
Posted by	90GoldZ on June 21, 2011 at 3:45 PM
	This message has been viewed 114 times.
In Reply To	Quick Question: What is the Inner Diameter of the 2 largish posted by MixManMash on June 21, 2011 at 03:12 PM
Message
Follow Ups	Quick Question: What is the Inner Diameter of the 2 largish - MixManMash 15:12:51 06/21/11 IIRC, 6mm (n/m) - BigTDogg (MA) 15:24:35 06/21/11 Oh, the ID? 6mm is the hose size, I think that goes by ID (n/m) - BigTDogg (MA) 15:25:23 06/21/11 That's for the control line to the recirc. But what about - MixManMash 15:25:55 06/21/11 Der, my bad. I can measure my silicone ones tongiht - BigTDogg (MA) 15:29:41 06/21/11 Thanks! Much appreciated. (n/m) - MixManMash 15:35:47 06/21/11 35mm ID on the pressurized side - BigTDogg (MA) 20:27:16 06/21/11 Should be ~28mm I.D. (n/m) - 90GoldZ 15:45:00 06/21/11 for which one? I believe the 2 are different diameters. (n/m) - MixManMash 17:42:09 06/21/11 That's the U-hose coming off ot the recirc - 90GoldZ 21:34:58 06/21/11 Both sizes - 90GoldZ 22:26:54 06/21/11 Thanks 2 both of you guys. (n/m) - MixManMash 00:23:02 06/22/11
Post a Followup	You cannot reply to this message because you are not logged in.