Subject	Answers>>>
Posted by	LitlElvis on June 15, 2011 at 3:54 PM
	This message has been viewed 177 times.
In Reply To	Re: My Low-Profile mounts use the exact same bushings as posted by DbestiZ1 on June 15, 2011 at 07:27 AM
Message	The picture posted by the OP are the Low-Profile mounts, and I'm told by Ash that they clear his new turbo inlet pipes (not IC pipes) without any modifications required. My new Billet Motor Mounts are a direct replacement for the factory vibration isolator only and are designed to work with the factory cast aluminum mount arms, which will not clear large diameter turbo inlet pipes without grinding.
Follow Ups	Thanks Brett! - ZiNnYc 20:16:41 06/14/11 Now everyone knows you're the reason they can't get theirs:) - LitlElvis 20:51:12 06/14/11 CD. That's funny. Hypothetically speaking Brett, if - Boosted1 06:08:24 06/15/11 Thanks for the heads up. - ZiNnYc 06:34:53 06/15/11 switching them around with engine installed would be - LitlElvis 06:52:37 06/15/11 Your labelling wasn't an issue. I had them on correct - Boosted1 19:57:14 06/15/11 Great to hear that demand has been good. - Dream Z 07:57:47 06/15/11 Unfortunately the 3076s are a project locked in time - LitlElvis 15:59:42 06/15/11 eh, he's alright (n/m) - vulcanrush 21:14:23 06/14/11 Re: Thanks Brett! - OleMissFan 23:45:45 06/14/11 My Low-Profile mounts use the exact same bushings as - LitlElvis 06:54:40 06/15/11 Re: My Low-Profile mounts use the exact same bushings as - DbestiZ1 07:27:43 06/15/11 Answers>>> - LitlElvis 15:54:44 06/15/11 parts whore!!! :) (n/m) - Cap927(Boston) 08:28:28 06/15/11 It looks like everyone in nyzc has the exact same setup! - induetime 10:34:44 06/15/11
Post a Followup	You cannot reply to this message because you are not logged in.