Subject	i doubt it would hurt the rigidity that much.
Posted by	twin3037 on June 06, 2011 at 10:01 PM
	This message has been viewed 181 times.
In Reply To	Great, then that means "nope" (n/m) posted by Zski on June 06, 2011 at 09:53 PM
Message	But the stress concentration worry me more. If you are dead set on it then debur it after you drill to reduce the chance of cracks forming
Follow Ups	Can I Drill Through this??? - Zski 21:43:17 06/06/11 A general idea of where "this" is may be helpful... (n/m) - Barry (NJ) 21:47:34 06/06/11 Next to Driveside Rear Strut (n/m) - Zski 21:50:25 06/06/11 looks like trunk, right next to left wheel well - twin3037 21:50:43 06/06/11 Great, then that means "nope" (n/m) - Zski 21:53:00 06/06/11 i doubt it would hurt the rigidity that much. - twin3037 22:01:42 06/06/11 I am not dead set on it... I am just lost on something... - Zski 22:06:14 06/06/11 yeah sure do it! (n/m) - Halo TTZ 21:55:24 06/06/11 What for? (n/m) - BigTDogg (MA) 22:24:41 06/06/11 you got mail.... (n/m) - Zski 22:30:49 06/06/11 Double check, I think that is for the fuel fill neck - FuerGrissa 22:24:43 06/06/11 Methanol Line pass through? (n/m) - TTFairladyZ 23:08:25 06/06/11 For meth lines? - 90GoldZ 23:25:49 06/06/11 The problem is not the Tank, its pump location (n/m) - Zski 23:38:23 06/06/11 Where are you planning on putting it? (n/m) - 90GoldZ 07:22:55 06/07/11 not sure.... (n/m) - Zski 08:27:32 06/07/11 Pretty sure you can as I think I did. - Woody75 (Denver) 11:26:24 06/07/11
Post a Followup	You cannot reply to this message because you are not logged in.