Subject	Re: Block bore size
Posted by	CmyZ on May 24, 2011 at 9:30 AM
	This message has been viewed 216 times.
In Reply To	Block bore size posted by dzero196 on May 23, 2011 at 04:50 PM
Message	The cylinder wall can handle the 1.0mm. If certain precautions are taken. If you are just going to bore. Then stay with 87.5mm. I would measure the cylinder wall thickness, depending on the results, then make your decision. I know not practical for many. But in my case I would go with the 88mm.
Follow Ups	Block bore size - dzero196 16:50:30 05/23/11 Re: Block bore size - Tech@EPR 16:59:48 05/23/11 I go with the smallest overbore needed to clean up the - aliaZ 18:50:44 05/23/11 ^^^ This is the best answer. (n/m) - LitlElvis 08:41:31 05/24/11 Re: Block bore size - CmyZ 21:25:59 05/23/11 Re: Block bore size - CmyZ 09:30:47 05/24/11
Post a Followup	You cannot reply to this message because you are not logged in.