Subject	I go with the smallest overbore needed to clean up the
Posted by	aliaZ on May 23, 2011 at 6:50 PM
	This message has been viewed 839 times.
In Reply To	Block bore size posted by dzero196 on May 23, 2011 at 04:50 PM
Message	cylinders to minimize the chance of bore flex The difference between 87.5mm and 88mm is a whopping .034 liters The difference between 87.5mm and 89mm is .103 liters Not worth the potential tradeoff in cylinder wall integrity IMHO, considering how thin the bores are. I've measured as thin as .120" cylinder wall thickness...a 89mm piston will remove another .040" from that...
Follow Ups	Block bore size - dzero196 16:50:30 05/23/11 Re: Block bore size - Tech@EPR 16:59:48 05/23/11 I go with the smallest overbore needed to clean up the - aliaZ 18:50:44 05/23/11 ^^^ This is the best answer. (n/m) - LitlElvis 08:41:31 05/24/11 Re: Block bore size - CmyZ 21:25:59 05/23/11 Re: Block bore size - CmyZ 09:30:47 05/24/11
Post a Followup	You cannot reply to this message because you are not logged in.