Subject	Re: Block bore size
Posted by	Tech@EPR on May 23, 2011 at 4:59 PM
	This message has been viewed 333 times.
In Reply To	Block bore size posted by dzero196 on May 23, 2011 at 04:50 PM
Message	general rule of thumb is anytime you can increase displacement and bore size you lean more in the green on power/tq production. Some play it safe and want to stay .020" over in case they have a blow out and have to rebuild again due to cylinder bore damage but I go straight to .040" over and get the best bang for the buck. You can go up to an 89mm bore but its starting to get thin on wall thickness. But its definitely doable and has been done many times with great success.
Follow Ups	Block bore size - dzero196 16:50:30 05/23/11 Re: Block bore size - Tech@EPR 16:59:48 05/23/11 I go with the smallest overbore needed to clean up the - aliaZ 18:50:44 05/23/11 ^^^ This is the best answer. (n/m) - LitlElvis 08:41:31 05/24/11 Re: Block bore size - CmyZ 21:25:59 05/23/11 Re: Block bore size - CmyZ 09:30:47 05/24/11
Post a Followup	You cannot reply to this message because you are not logged in.