Subject	Re: SZR...modifying radio bezel...need help
Posted by	CmyZ on May 20, 2011 at 9:07 AM
	This message has been viewed 126 times.
In Reply To	SZR...modifying radio bezel...need help posted by Nitehawk on May 20, 2011 at 08:54 AM
Message	Depending on your current fit, try to not cut more than needed on the bezel. Patience is your friend. Its is better to sand, than to refill the areas. Then weld as fuergrissa indicates if necessary.
Follow Ups	SZR...modifying radio bezel...need help - Nitehawk 08:54:44 05/20/11 the best way would be - FuerGrissa 09:01:04 05/20/11 Harbor Freight sells a plastic welder (n/m) - CoHPhasor 12:50:21 05/20/11 Re: SZR...modifying radio bezel...need help - CmyZ 09:07:33 05/20/11 Link to a good write up - 96300NAZ 10:30:44 05/20/11 Re: Link to a good write up - Nitehawk 11:26:56 05/20/11
Post a Followup	You cannot reply to this message because you are not logged in.