TwinTurbo.NET: Nissan 300ZX forum - I moved the crankshaft back & forth w/o fully torquing down
People Seeking Info
 
   


     
Subject I moved the crankshaft back & forth w/o fully torquing down
     
Posted by sparkie on May 18, 2011 at 11:18 AM
  This message has been viewed 292 times.
     
In Reply To Looks great! A question though.. posted by KongZTT GT28RS MD on May 18, 2011 at 05:48 AM
     
Message the cap over the thrust bearing. Then to set the thrust, you would have to torque down the cap to accurately set the end play. The same way you measure the crank end play when the engine is in the car.

www.ztechz.net

ICQ # 14337317

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.