Subject	Re: very carefully
Posted by	darkmann on May 15, 2011 at 10:47 PM
	This message has been viewed 155 times.
In Reply To	very carefully posted by ZXoltan on May 15, 2011 at 05:32 PM
Message	Thanks ZXoltan. That's the clip. What kind of plastic tool do you use. I have a plastic wedge for inside trim removal but it's edge will be too thick for this job. Any suggestions?
Follow Ups	How Do I take off Rear Trim with NISSAN logo? - darkmann 15:12:14 05/15/11 That panel is very thin, be very carefull... - rave 15:22:35 05/15/11 Re: That panel is very thin, be very carefull... - darkmann 15:40:52 05/15/11 If you are saving the panel I would NOT just break them... - rave 16:06:36 05/15/11 Re: If you are saving the panel I would NOT just break them... - darkmann 16:15:49 05/15/11 I would find a set of long and thin needlenose pliers - LJZTT 16:46:09 05/15/11 They turn red due to fading.... (n/m) - jzack 18:27:37 05/15/11 You're joking right on never seeing red faded 3rd brake - Gennosuke 20:43:14 05/15/11 2nd'ed - MrOzzie5183 21:11:34 05/15/11 Re: You're joking right on never seeing red faded 3rd brake - darkmann 22:42:32 05/15/11 Courtesy of Ric Q... - Barry (NJ) 13:26:30 05/16/11 On a car courtesy of MrOzzie5183... - Barry (NJ) 15:02:04 05/16/11 You beat me to it, I was about to point that out - Gennosuke 15:30:25 05/16/11 very carefully - ZXoltan 17:32:28 05/15/11 Re: very carefully - darkmann 22:47:30 05/15/11 Squeeze the tabs with a pair of needle nose. They're are - black300zx 11:56:34 05/16/11
Post a Followup	You cannot reply to this message because you are not logged in.