Subject	Slicktop Progress Part 4
Posted by	toykoz32 on May 14, 2011 at 12:55 PM
	This message has been viewed 1051 times.
Message	Made a little progress this past week I got the rest of the piece's back from the powder coat-er, and Installed the piece's need to drop in the motor. I still need to do the 120k on the motor, re-seal the oil pan, new oil pump, new rear main seal retainer gasket and new rear main seal. I put on some shocks/struts with a some godspeed suspension piece's. I got a deal on a set of built heads with under 2k on them with new lifters/JWT R4 cams/ HD springs/ 3 angle valve job and a mild port and polish that im really thinking about putting on the slicktop NA engine. any problem with running those cams on a NA? O I also did a wire tuck here are a few photos. I have all splash shields so no was should get to the fuse box. I will also be lining the edge of the fuse box with weather stripping. Maybe even make a plastic cover that uses velco to cover the entire box. The roof, front lower lip, IC slits and maybe part of the rear spoiler will be wrapped in a Matte Carbon Fiber vinyl wrap. The roof, front lower lip, IC slits and maybe part of the rear spoiler will be wrapped in a Matte Carbon Fiber vinyl wrap, something like so . . .
Follow Ups	Slicktop Progress Part 4 - toykoz32 12:55:50 05/14/11 very nice, i would say no to the carbon fiber look wrap - Sleeper_TTZ(SeKy) 13:15:32 05/14/11 You should pull your brake booster - Shiers69 14:33:28 05/14/11 On the list of things to do (n/m) - toykoz32 15:01:37 05/14/11 Just say "no" to fake CF wrap. (n/m) - bstyleZ 15:20:04 05/14/11 Looks good. I hope after all that you - Boosted1 07:50:23 05/15/11 Keep it going. - Milo (SATX) 23:14:00 05/15/11
Post a Followup	You cannot reply to this message because you are not logged in.