Subject	I believe most boost controllers don't do anything with the
Posted by	Wright (Ca) on May 08, 2011 at 2:09 PM
	This message has been viewed 176 times.
In Reply To	but the boost solenoid isn't what "reads" pressure posted by Madhatter10-6 on May 08, 2011 at 10:12 AM
Message	boost sensor readings. It's just there for reference. When you make adjustments you are tweaking the duty cycle of the BC solenoid. That's why in colder weather you will make more boost even though you did not change any settings...the ebc doesn't give a shit what the boost sensor is reading. Connecting the solenoid's boost source post-tb's will cause the turbo to continue to build boost after the tb's are closed putting damaging back pressure on the turbo compressor. Formerly: ZEVAN (Ca), Evan3zx(ca)
Follow Ups	Boost solenoid feed location? - Madhatter10-6 12:47:52 05/06/11 just T it off under the nose panel with brass fittings (n/m) - blackomega 13:08:07 05/06/11 thanks (n/m) - Madhatter10-6 20:50:48 05/06/11 I believe the reason behind doing it before is to prevent - 5280Z_nightstalker 13:12:20 05/06/11 You might want to keep the waste gates powered open a - not4resaleZ 13:48:59 05/06/11 Why would you want to tie in behind the TB's? (n/m) - zellamay 17:11:08 05/06/11 Never said I did... - Madhatter10-6 20:49:23 05/06/11 Think about what would happen at partial thorttle. - dogpile 17:15:28 05/06/11 Sorry, larger pressure difference than at WOT. (n/m) - dogpile 17:22:41 05/06/11 When the TB-Butterfly closes, what's behind it goes to - Barry (NJ) 14:43:44 05/07/11 Would th BOV/Recirc valve not normalize the difference? - JMW300ZX 18:52:33 05/07/11 The boost controller reads the boost pressure, then - zellamay 21:23:48 05/07/11 but the boost solenoid isn't what "reads" pressure - Madhatter10-6 10:12:38 05/08/11 I believe most boost controllers don't do anything with the - Wright (Ca) 14:09:10 05/08/11 your mixed up on a few things. - Antihero 11:59:26 05/08/11 Only need one side of the system too, can just cap - BigTDogg (MA) 06:21:37 05/08/11 2nd. No need to Tee from both sides. - Wright (Ca) 14:13:27 05/08/11
Post a Followup	You cannot reply to this message because you are not logged in.