Subject	Could also try..
Posted by	Milo (SATX) on May 06, 2011 at 8:14 AM
	This message has been viewed 137 times.
In Reply To	Swap Progress posted by evan_aggie on May 06, 2011 at 12:28 AM
Message	Putting a few more turns on the fitting to the rail to close the gap a bit more. Lastly, as a last resort, go from a 90 to a 180 AN fitting to give you a little more space.
Follow Ups	Swap Progress - evan_aggie 00:28:46 05/06/11 Pull the whole heater core pipe away from the motor a few mm (n/m) - Bernie (NoVA) 00:34:44 05/06/11 I did that a little. I guess I need to pull it more. (n/m) - evan_aggie 00:55:26 05/06/11 Could also try.. - Milo (SATX) 08:14:39 05/06/11 Nice and clean. (n/m) - Spongerider :) 10:58:09 05/06/11 And, here is the part I selectively withheld... - evan_aggie 13:02:01 05/06/11 very nice. (n/m) - Ziceman(East TN) 12:30:04 05/06/11 Very nice... (n/m) - Zski 16:09:40 05/06/11
Post a Followup	You cannot reply to this message because you are not logged in.