TwinTurbo.NET: Nissan 300ZX forum - Took a little bit to figure out the piping
People Seeking Info
 
   


     
Subject Took a little bit to figure out the piping
     
Posted by TTFairladyZ on May 03, 2011 at 12:19 AM
  This message has been viewed 219 times.
     
In Reply To finally! posted by Ahmed (Chicago) on May 02, 2011 at 02:49 PM
     
Message But everything is bolted up and engine dropped back in. We did the timing belt and when we were just about to put the new ATI pulley on, there was RameyZ idler studs in the box that Eric forgot to tell us about. So we needed to set the belt on again. Fun stuff


1990 Nissan 300ZXTT Stage III+
11.96 e.t. 1.61 60ft on original stock turbos

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.