Subject	FYI
Posted by	blackomega on April 29, 2011 at 2:22 PM
	This message has been viewed 972 times.
Message	compare and contrast: AlloyToyz 3" vs SZ 3" Totally swapped out at 3AM. You can tell what kind of mood I was in by looking at the (probably perfectly fine) O2 sensor ___________________ "If everybody is thinking alike, somebody isn't thinking." ~~ George S. Patton
Follow Ups	FYI - blackomega 14:22:27 04/29/11 which one is which? (n/m) - thumper 14:38:08 04/29/11 SZ on right in first pic (n/m) - BigTDogg (MA) 14:44:39 04/29/11 The biggest difference - Justin (Staten Island, NY) 14:56:32 04/29/11 There are lots of differences. - blackomega 15:29:18 04/29/11 tc ring? looks exactly like mine. (n/m) - fantomZ(OH) 15:21:40 04/29/11 yes - blackomega 15:26:28 04/29/11 nice, mine is simple/polished . - fantomZ(OH) 15:50:40 04/29/11 its tough and polishes up good as new (n/m) - blackomega 16:28:18 04/29/11 but heavy as all hell. I went with Ti, feels like I'm not - zgene4 17:37:04 04/29/11 Wife an I both have Ti rings. (n/m) - lazer(NJ) 18:57:49 04/29/11 Careful with those rings, consider taking off when you work - FuerGrissa 19:58:54 04/29/11 Any ER that cuts off a finger - ZiNnYc 21:12:27 04/29/11 to be fair I don't know of it ever happening - FuerGrissa 22:34:25 04/29/11 I've heard that they can be broken off, but not cut. - fantomZ(OH) 22:08:28 04/29/11 Tungsten Carbide? (n/m) - thumper 16:27:54 04/29/11 i feel like the red headed stepchild... - thumper 23:12:01 04/29/11 lol. Yes, tungsten carbide:) (n/m) - fantomZ(OH) 08:25:09 04/30/11 Thanks! :) (n/m) - thumper 11:16:42 04/30/11 what's that? - Gromit 20:02:08 04/30/11 What prompted the switch? (n/m) - Evan(CA) 16:50:19 04/29/11 long story, check tech section for very short version - blackomega 16:53:36 04/29/11 Not looking to start any crap but - soulpwr 17:29:40 04/29/11 asuming you can get the knock-off's to seal properly - FuerGrissa 20:05:57 04/29/11 true - blackomega 21:52:59 04/29/11 Not looking to start any crap but - soulpwr 19:02:13 04/29/11
Post a Followup	You cannot reply to this message because you are not logged in.