TwinTurbo.NET: Nissan 300ZX forum - My Alpine IDA X100 has no problem
People Seeking Info
 
   


     
Subject My Alpine IDA X100 has no problem
     
Posted by BlackholeZ on April 25, 2011 at 11:56 AM
  This message has been viewed 138 times.
     
In Reply To No HU I've ever seen can effectively drive components (n/m) posted by BigTDogg (MA) on April 25, 2011 at 11:44 AM
     
Message Only 18x4 RMS, and I have no problem rocking out on the highway with the tops out. I have subs to take the load off the components in the low end, and had Zmax Systems install new components in the stock enclosures. Everything sounds good, from classical to dubstep. The only thing I think about doing is adding some tweeters in the dash or doors up front.

-Dan

"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" - ChristopherTheOne
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.