Subject	Are the nuts and bolts that connect the Turbos to the
Posted by	Barry (NJ) on April 24, 2011 at 7:29 AM
	This message has been viewed 258 times.
Message	down-pipes special, or will hardened fasteners from Ace suffice?
Follow Ups	Are the nuts and bolts that connect the Turbos to the - Barry (NJ) 07:29:46 04/24/11 the OEM nuts and bolts are inconel - aliaZ 07:38:53 04/24/11 They are inconel, but I have seen regular nuts and bolts - na300zx (OH) 07:38:58 04/24/11 Its not. (n/m) - Bernie (NoVA) 21:01:13 04/24/11 Thanks guys, I'll get some new OEM hardware. (n/m) - Barry (NJ) 07:43:40 04/24/11 Yeah, the heat will do them in. Go inconel. (n/m) - phillyz 09:35:41 04/24/11 yep I used some from hardware store, constantly back off (n/m) - LJZTT 10:55:13 04/24/11 Yup - break out your wallet - they're not cheap :-) (n/m) - spicyZ 12:23:12 04/24/11 Ka-Boom ! (n/m) - ttz'in (NorCal) 13:30:07 04/24/11 Hey Steve, how is the swap going? (n/m) - Wright (Ca) 17:32:24 04/24/11 All depends..... - platupus 01:42:59 04/25/11 I find that hard to believe (n/m) - ZiNnYc 06:20:49 04/25/11 "Stainless"? Stainless tends to be softer than most other - Barry (NJ) 07:01:45 04/25/11 Weaker at room temperature, but stronger in high heat - Marshall 12:09:08 04/25/11 Inconel is just an expensive stainless as well. - BigTDogg (MA) 14:08:39 04/25/11 False Stainless hardware is not correct for this application (n/m) - Bernie (NoVA) 08:35:58 04/25/11 Been there. Use OEM only! Thank self later. (n/m) - .z 18:23:04 04/25/11
Post a Followup	You cannot reply to this message because you are not logged in.