TwinTurbo.NET: Nissan 300ZX forum - Well put sir!
Subject
Well put sir!
Posted by
Nick (ASH-SPEC)
on April 19, 2011 at 10:17 AM
This message has been viewed
83
times.
In Reply To
Seems like a "Well since the motor is all ready out sort of
posted by samsungz
on April 18, 2011 at 06:57 PM
Message
Follow Ups
Turbo Housing Modifications
-
Nick (ASH-SPEC)
15:45:58 04/18/11
Lookin good!
-
ZiNnYc
16:40:10 04/18/11
Re: Lookin good!
-
Ash's Z
17:36:57 04/18/11
That's like what BEGi does, but actually clean. Good work (n/m)
-
dogpile
16:46:55 04/18/11
hmm.. kinda seems like a lot of work for the gain doesnt it?
-
fst300zx
17:46:45 04/18/11
Seems like a "Well since the motor is all ready out sort of
-
samsungz
18:57:18 04/18/11
Well put sir! -
Nick (ASH-SPEC)
10:17:47 04/19/11
Re: hmm.. kinda seems like a lot of work for the gain doesnt it?
-
Nick (ASH-SPEC)
10:15:09 04/19/11
you havent had any problems with warpage?
-
KongZTT GT28RS MD
19:16:51 04/18/11
I've also heard it's not so good to weld on the
-
ForceFedTT (SoCal)
22:32:17 04/18/11
I've seen no indications that welding the flange to the
-
Ash's Z
07:54:05 04/19/11
Also,.. I'm not knockin anything...
-
KongZTT GT28RS MD
11:00:38 04/19/11
Corky Bell does it all the time.
-
dogpile
08:50:52 04/19/11
Re: Corky Bell does it all the time.
-
Nick (ASH-SPEC)
10:21:34 04/19/11
I never heard of a failure related to it, no. I even ran
-
dogpile
10:50:09 04/19/11
FWIW.. JWT didn't weld the compressor inlet flanges..
-
KongZTT GT28RS MD
10:57:03 04/19/11
Dunno. I never heard not to, and Corky himself mentioned it
-
dogpile
11:15:21 04/19/11
here, only pic I have of what BEGi did to my turbo inlet
-
dogpile
11:11:54 04/19/11
Post a
Followup
You cannot reply to this message because you are not
logged in
.