Subject	I've seen no indications that welding the flange to the
Posted by	Ash's Z on April 19, 2011 at 7:54 AM
	This message has been viewed 147 times.
In Reply To	you havent had any problems with warpage? posted by KongZTT GT28RS MD on April 18, 2011 at 07:16 PM
Message	housing is causing any warpage at all. There's an oring seal between the comp housing and the cartridge anyhow that would be more than capable of sealing it up even if it were to warp a thou or two. You would have to seriously heat and intentionally distort the part to warp it enough to cause any issues... like browtorch and vice and hammers - little shop of horrors kind of stuff. Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor. Albert Einstein
Follow Ups	Turbo Housing Modifications - Nick (ASH-SPEC) 15:45:58 04/18/11 Lookin good! - ZiNnYc 16:40:10 04/18/11 Re: Lookin good! - Ash's Z 17:36:57 04/18/11 That's like what BEGi does, but actually clean. Good work (n/m) - dogpile 16:46:55 04/18/11 hmm.. kinda seems like a lot of work for the gain doesnt it? - fst300zx 17:46:45 04/18/11 Seems like a "Well since the motor is all ready out sort of - samsungz 18:57:18 04/18/11 Well put sir! - Nick (ASH-SPEC) 10:17:47 04/19/11 Re: hmm.. kinda seems like a lot of work for the gain doesnt it? - Nick (ASH-SPEC) 10:15:09 04/19/11 you havent had any problems with warpage? - KongZTT GT28RS MD 19:16:51 04/18/11 I've also heard it's not so good to weld on the - ForceFedTT (SoCal) 22:32:17 04/18/11 I've seen no indications that welding the flange to the - Ash's Z 07:54:05 04/19/11 Also,.. I'm not knockin anything... - KongZTT GT28RS MD 11:00:38 04/19/11 Corky Bell does it all the time. - dogpile 08:50:52 04/19/11 Re: Corky Bell does it all the time. - Nick (ASH-SPEC) 10:21:34 04/19/11 I never heard of a failure related to it, no. I even ran - dogpile 10:50:09 04/19/11 FWIW.. JWT didn't weld the compressor inlet flanges.. - KongZTT GT28RS MD 10:57:03 04/19/11 Dunno. I never heard not to, and Corky himself mentioned it - dogpile 11:15:21 04/19/11 here, only pic I have of what BEGi did to my turbo inlet - dogpile 11:11:54 04/19/11
Post a Followup	You cannot reply to this message because you are not logged in.