Subject	I've also heard it's not so good to weld on the
Posted by	ForceFedTT (SoCal) on April 18, 2011 at 10:32 PM
	This message has been viewed 130 times.
In Reply To	you havent had any problems with warpage? posted by KongZTT GT28RS MD on April 18, 2011 at 07:16 PM
Message	compressor outlets as well because it can change its shape. Hmmm..
Follow Ups	Turbo Housing Modifications - Nick (ASH-SPEC) 15:45:58 04/18/11 Lookin good! - ZiNnYc 16:40:10 04/18/11 Re: Lookin good! - Ash's Z 17:36:57 04/18/11 That's like what BEGi does, but actually clean. Good work (n/m) - dogpile 16:46:55 04/18/11 hmm.. kinda seems like a lot of work for the gain doesnt it? - fst300zx 17:46:45 04/18/11 Seems like a "Well since the motor is all ready out sort of - samsungz 18:57:18 04/18/11 Well put sir! - Nick (ASH-SPEC) 10:17:47 04/19/11 Re: hmm.. kinda seems like a lot of work for the gain doesnt it? - Nick (ASH-SPEC) 10:15:09 04/19/11 you havent had any problems with warpage? - KongZTT GT28RS MD 19:16:51 04/18/11 I've also heard it's not so good to weld on the - ForceFedTT (SoCal) 22:32:17 04/18/11 I've seen no indications that welding the flange to the - Ash's Z 07:54:05 04/19/11 Also,.. I'm not knockin anything... - KongZTT GT28RS MD 11:00:38 04/19/11 Corky Bell does it all the time. - dogpile 08:50:52 04/19/11 Re: Corky Bell does it all the time. - Nick (ASH-SPEC) 10:21:34 04/19/11 I never heard of a failure related to it, no. I even ran - dogpile 10:50:09 04/19/11 FWIW.. JWT didn't weld the compressor inlet flanges.. - KongZTT GT28RS MD 10:57:03 04/19/11 Dunno. I never heard not to, and Corky himself mentioned it - dogpile 11:15:21 04/19/11 here, only pic I have of what BEGi did to my turbo inlet - dogpile 11:11:54 04/19/11
Post a Followup	You cannot reply to this message because you are not logged in.