Subject	hmm.. kinda seems like a lot of work for the gain doesnt it?
Posted by	fst300zx on April 18, 2011 at 5:46 PM
	This message has been viewed 193 times.
In Reply To	Turbo Housing Modifications posted by Nick (ASH-SPEC) on April 18, 2011 at 03:45 PM
Message	I mean what is the benefit of this versus just stepping the piping down to the flange on the turbo? What was the recorded gain between the V1 and V1 inlet systems or was the results never completed. Last i heard it was right there and then injector failure? Matt ">
Follow Ups	Turbo Housing Modifications - Nick (ASH-SPEC) 15:45:58 04/18/11 Lookin good! - ZiNnYc 16:40:10 04/18/11 Re: Lookin good! - Ash's Z 17:36:57 04/18/11 That's like what BEGi does, but actually clean. Good work (n/m) - dogpile 16:46:55 04/18/11 hmm.. kinda seems like a lot of work for the gain doesnt it? - fst300zx 17:46:45 04/18/11 Seems like a "Well since the motor is all ready out sort of - samsungz 18:57:18 04/18/11 Well put sir! - Nick (ASH-SPEC) 10:17:47 04/19/11 Re: hmm.. kinda seems like a lot of work for the gain doesnt it? - Nick (ASH-SPEC) 10:15:09 04/19/11 you havent had any problems with warpage? - KongZTT GT28RS MD 19:16:51 04/18/11 I've also heard it's not so good to weld on the - ForceFedTT (SoCal) 22:32:17 04/18/11 I've seen no indications that welding the flange to the - Ash's Z 07:54:05 04/19/11 Also,.. I'm not knockin anything... - KongZTT GT28RS MD 11:00:38 04/19/11 Corky Bell does it all the time. - dogpile 08:50:52 04/19/11 Re: Corky Bell does it all the time. - Nick (ASH-SPEC) 10:21:34 04/19/11 I never heard of a failure related to it, no. I even ran - dogpile 10:50:09 04/19/11 FWIW.. JWT didn't weld the compressor inlet flanges.. - KongZTT GT28RS MD 10:57:03 04/19/11 Dunno. I never heard not to, and Corky himself mentioned it - dogpile 11:15:21 04/19/11 here, only pic I have of what BEGi did to my turbo inlet - dogpile 11:11:54 04/19/11
Post a Followup	You cannot reply to this message because you are not logged in.