Subject	Yup that's what I did, those inner sleeves are a pain though
Posted by	Adamo on April 11, 2011 at 6:57 PM
	This message has been viewed 216 times.
In Reply To	What if I use a hole saw to remove the inner portion posted by Cap927(Boston) on April 11, 2011 at 01:01 PM
Message	Although I didn't cut them saw was broken so I hammered them out.
Follow Ups	can not find any info/tips on rear control arm/axle bushing - Cap927(Boston) 11:59:31 04/11/11 What are you replacing them with? (n/m) - Bernie (NoVA) 12:26:06 04/11/11 Nismo bushing kit and SPL V3 upper control arm. (n/m) - Cap927(Boston) 12:39:31 04/11/11 My 20 ton press was at its limits, I doubt a threaded rod - just4kinks 12:50:30 04/11/11 thanks for the tips, front is done already. (n/m) - Cap927(Boston) 12:54:30 04/11/11 What if I use a hole saw to remove the inner portion - Cap927(Boston) 13:01:34 04/11/11 That's how I remove them. - Woody75 (Denver) 14:09:12 04/11/11 awesome thanks Woody. (n/m) - Cap927(Boston) 14:14:29 04/11/11 Yup that's what I did, those inner sleeves are a pain though - Adamo 18:57:09 04/11/11 I did all mine about two months ago and, - twin3037 14:16:56 04/11/11 I didn't want to mess with it - collegeboy 02:29:43 04/12/11 Same thing with the subframe bushings - collegeboy 02:32:41 04/12/11 Having done them once, the subframe is not fun - BigTDogg (MA) 09:30:16 04/12/11
Post a Followup	You cannot reply to this message because you are not logged in.