| is up to the job. If you buy a press for this, get one with a wide clearance between the posts. The HF 20 ton wasn't really big enough - I got it done but it was tricky. You'll also need a selection of heavy steel bars & spacers. Also, for RLCA bushings - the ones with the lip - freeze them and put a light oil before pressing. And get a washer or something so that you don't apply pressure at the outer edge of the lip - it will mushroom easily. And the RLCA is the hardest one to fit on the press, DON'T EVEN THINK about pressing one end while supporting at the other. You'll see what I mean when you get started. If you do the FLCA, you'll need to fab a spacer to put inside the channel. Email me if you have specific questions, I might have pictures somewhere.
 |
