Subject	remove timing belt off for that... BDE Cam Gear upgrade...hm (n/m)
Posted by	Jiro on April 09, 2011 at 9:41 PM
	This message has been viewed 182 times.
In Reply To	Thanks that makes sense. I will pull the head out as well (n/m) posted by Jiro on April 09, 2011 at 09:33 PM
Message
Follow Ups	Plenum Pull Plans... what else can i do? - Jiro 20:40:01 04/09/11 Have you read the plenum pull FAQ? - spicyZ 20:42:53 04/09/11 throttle body coolant lines bypass. (n/m) - mogaffar 20:45:14 04/09/11 ok I'll put that on my to do list - Jiro 20:53:31 04/09/11 Plenum pull - Roundabout136 21:04:41 04/09/11 2nd, Figured that went w/o saying and was in the FAQ (n/m) - CoHPhasor 21:26:59 04/09/11 Water hoses, period. - CoHPhasor 21:16:14 04/09/11 Then I'll do the MT tranny swap as well. Rear main seal... (n/m) - Jiro 21:43:13 04/09/11 I guess then i could swap these turbos in... MS manifolds. - Jiro 21:46:33 04/09/11 I wouldn't Heli-Coil the head with it attached to the motor. (n/m) - Barry (NJ) 21:29:17 04/09/11 Thanks that makes sense. I will pull the head out as well (n/m) - Jiro 21:33:53 04/09/11 remove timing belt off for that... BDE Cam Gear upgrade...hm (n/m) - Jiro 21:41:31 04/09/11 ! (n/m) - 240Z FeO2 22:28:06 04/09/11 ? (n/m) - Barry (NJ) 20:35:06 04/10/11 In retrospect, too ambiguous. What I meant was to add - 240Z FeO2 23:32:37 04/11/11 One thing leads to another and another... you'll probably - nonstopna 12:22:35 04/10/11
Post a Followup	You cannot reply to this message because you are not logged in.