Subject	Speaking of Harbor Freight do you have their bearing puller?
Posted by	5280Z_nightstalker on April 01, 2011 at 1:25 PM
	This message has been viewed 76 times.
In Reply To	I buy my "specialty tools".. like slide hammer bearing pulle posted by KongZTT GT28RS MD on April 01, 2011 at 08:20 AM
Message	Have you used it doing the subframe bushings? How did it do if you did use it for that? Im going to be replacing my subframe bushings and differential bushings soon so I figure I might as well start looking for a good tool and make my life easier. "Do you guys put the key in "balls down", or up?" -BobbyT 10:28:19 03/06/09
Follow Ups	NZR where do you guys buy tools from? - Rob260 05:32:32 04/01/11 I buy my "specialty tools".. like slide hammer bearing pulle - KongZTT GT28RS MD 08:20:46 04/01/11 whoops.. didnt see "power tools" in the post :) - KongZTT GT28RS MD 11:45:43 04/01/11 Speaking of Harbor Freight do you have their bearing puller? - 5280Z_nightstalker 13:25:27 04/01/11 I have not used it for that yet.. - KongZTT GT28RS MD 00:42:42 04/02/11 pawn shops (n/m) - Adam (NoVA) 10:56:00 04/01/11 Thats actually not a bad idea.. - KongZTT GT28RS MD 00:44:09 04/02/11 i think alot get lifted from job sites - Adam (NoVA) 09:46:40 04/03/11 i like some of the Ridgid tools from home depot. - slayer fan 11:38:42 04/01/11 Snap On, cornwell, sears (craftsman) (n/m) - John (MD) 21:58:21 04/01/11 proto and blackhawk are very good too.. - KongZTT GT28RS MD 00:45:01 04/02/11
Post a Followup	You cannot reply to this message because you are not logged in.