Subject	Could i just do the bearings then?
Posted by	BlackholeZ on March 21, 2011 at 3:22 PM
	This message has been viewed 104 times.
In Reply To	yeah on a z motor its like like a rod bearing about to die (n/m) posted by ztunerz on March 21, 2011 at 01:23 PM
Message	The motor still pulls strong. I haven't done a compression check, but plan to this week. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "Ahhh, VTEC. All of the lag, none of the turbo. It's like waiting for bad sex." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Roses are red, violets are blue, stages are gay, and so are you." - ZEngineer "Hoses as hard as Zengineer at a Hot Imports Night event" - Gizmo "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Well my Z is living up to it's name. - BlackholeZ 02:45:12 03/21/11 Curious how it was diagnosed as a "wrist pin". Most likely - Jc (Houston) 03:16:20 03/21/11 Re: Curious how it was diagnosed as a "wrist pin". Most likely (n/m) - Tony90zx 04:31:14 03/21/11 I've got a quart of rislone in it right now - BlackholeZ 11:08:48 03/21/11 yeah on a z motor its like like a rod bearing about to die (n/m) - ztunerz 13:23:01 03/21/11 Could i just do the bearings then? - BlackholeZ 15:22:01 03/21/11 You could.. as long as the journals are okay.. - KongZTT GT28RS MD 15:30:41 03/21/11 Yup, gonna be a rod bearing. (n/m) - Jc (Houston) 19:03:03 03/22/11 I will have an NA motor for sale - 92ZLuke (CA) 10:22:47 03/21/11 Any suggestions regarding heavier oils? - BlackholeZ 16:25:03 03/21/11
Post a Followup	You cannot reply to this message because you are not logged in.