Subject	You need to set your pads 1st.
Posted by	Bernie (NoVA) on March 17, 2011 at 9:48 AM
	This message has been viewed 167 times.
In Reply To	Just me? I cannot find the L+R new 2+0 parking brake cables posted by 91300zxttkid on March 17, 2011 at 07:33 AM
Message	Cables alone wont "stretch" that far. Bernie Bilski berniebilski@cox.net 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red ZCCNV #390 ~ ECZA #368
Follow Ups	Just me? I cannot find the L+R new 2+0 parking brake cables - 91300zxttkid 07:33:00 03/17/11 Link - njz 07:39:32 03/17/11 What's the condition of the brake shoes and have you - Cap927(Boston) 08:10:52 03/17/11 you check the pads first? - TeddyZ(SFC) 08:12:56 03/17/11 Thanks guys, I will be removing the hubs tomorrow - 91300zxttkid 08:26:05 03/17/11 im not sure if there is a measurement... - TeddyZ(SFC) 08:33:16 03/17/11 You need to set your pads 1st. - Bernie (NoVA) 09:48:22 03/17/11 thanks, from what i remember, i adjusted the little star - 91300zxttkid 10:14:05 03/17/11 2nd (n/m) - KongZTT GT28RS MD 10:46:01 03/17/11 what's the pad thickness when new, 1/4 or more ? (n/m) - njz 11:10:27 03/17/11 less than a 1/4, I would say 5 cm or 3/16" at most. IIRC (n/m) - Cap927(Boston) 11:16:55 03/17/11 Re: less than a 1/4, I would say 5 cm or 3/16" at most. IIRC - njz 12:42:08 03/17/11 Did you adjust the shoes/pads first as mentioned by LJZTT? - Cap927(Boston) 13:16:15 03/17/11 Yes, adjusted till tight and then backed off a bit. (n/m) - njz 13:35:28 03/17/11 Also IIRC there is an adjustment on the single cable - Cap927(Boston) 13:46:27 03/17/11 Checking now (n/m) - njz 14:17:05 03/17/11 OK, I see the T, but can't see who to adjust the - njz 14:49:49 03/17/11 not saying your cable isnt stretched, obviously I dont know - LJZTT 15:04:10 03/17/11 there is a nut @ the base of the hangle where the cable - Bernie (NoVA) 15:23:50 03/17/11 I had the same problem - LJZTT 10:49:39 03/17/11 how bad do you want my spare ;) (n/m) - SuparexTT 19:17:07 03/17/11
Post a Followup	You cannot reply to this message because you are not logged in.