Subject	If picking up tips from here, rule #1 wasn't observed
Posted by	CoHPhasor on March 15, 2011 at 11:12 PM
	This message has been viewed 188 times.
In Reply To	my first Z32 rebuild.. posted by tt_703 on March 15, 2011 at 10:08 PM
Message	If the engine comes out, so does the harness! (It would've helped with overspray on it) FYI, *if* you do wish to remove the harness completely, there is a bracket under the dash EXACTLY where the harness comes through the firewall. 2 bolts hold the bracket, undo it, or simply cut it off to get the room to pull it through. (De-pinning the one connector, or bending the firewall is ridiculous when this solution is so easy) You had the water galleys cleaned out when you had the shop work over the block? It's alot of work, lots of blood and sweat, I hope you truly get to enjoy it later. :-)
Follow Ups	my first Z32 rebuild.. - tt_703 22:08:15 03/15/11 Good work so far. A tip: to keep paint overspray to a - Jkova300z 22:16:16 03/15/11 Re: Good work so far. A tip: to keep paint overspray to a - tt_703 06:47:29 03/16/11 Welcome to hell. I'm guessing you've figured out there isn't - Sleeper_TTZ(SeKy) 22:25:53 03/15/11 looks like a RameyZ slinger to me (n/m) - thumper 16:32:24 03/16/11 Nice color... - BradX (UF) 23:09:31 03/15/11 If picking up tips from here, rule #1 wasn't observed - CoHPhasor 23:12:49 03/15/11 Re: my first Z32 rebuild.. - CmyZ 07:37:37 03/16/11 Re: my first Z32 rebuild.. - jaidieray 17:32:21 03/17/11
Post a Followup	You cannot reply to this message because you are not logged in.