Subject	The egr ports on the plenum are different
Posted by	reptile28 on March 15, 2011 at 6:53 PM
	This message has been viewed 166 times.
In Reply To	I have a few pics from the install in a photobucket album. posted by Wright (Ca) on March 15, 2011 at 05:40 PM
Message	When I tried to install the plenum from a j30 the egr did not fit into the underside. The angle was off. I have to use the j30 egr tubes in order to get it to fit.
Follow Ups	J30 Power steering brackets bolt up to a 94+ pump? - KongZTT GT28RS MD 15:51:12 03/15/11 I believe that they are different. The J30 set up doesn't - Bernie (NoVA) 16:07:18 03/15/11 thank you! - KongZTT GT28RS MD 16:09:35 03/15/11 Also.. As the the J30 plenums.. - KongZTT GT28RS MD 16:15:56 03/15/11 There are a few minor casting differences... - Bernie (NoVA) 16:26:23 03/15/11 Perfect.. Thanks again Bernie (n/m) - KongZTT GT28RS MD 16:42:30 03/15/11 I used a pump and brackets from a j30 for my hicas - Wright (Ca) 17:19:03 03/15/11 Nice. (n/m) - Bernie (NoVA) 17:23:41 03/15/11 I have a few pics from the install in a photobucket album. - Wright (Ca) 17:40:17 03/15/11 The egr ports on the plenum are different - reptile28 18:53:48 03/15/11 Or you could use a wrench to turn twist it into position - toykoz32 19:36:23 03/15/11 That's true of any plenum that also has the throttle spring - Bernie (NoVA) 20:13:24 03/15/11 Cool Thanks! (n/m) - KongZTT GT28RS MD 19:52:19 03/15/11 They will work. (n/m) - Woody75 (Denver) 07:56:46 03/16/11
Post a Followup	You cannot reply to this message because you are not logged in.