Subject	Thanx , I appreciate the thoughts and concerns .
Posted by	xteam300tt on March 08, 2011 at 12:11 PM
	This message has been viewed 155 times.
In Reply To	Nice work... posted by Jim (Selin Design) on March 08, 2011 at 11:58 AM
Message	I know exactly what your saying and my plan is to fill in the inside gap and then smooth it back out so it tappers into the flange and removes any gaps from pipe to flange . I wasnt sure if i was going to do that but now I am . Thanx again for the input .
Follow Ups	My solution to the 2.5" inlet pipes >>> - xteam300tt 09:45:32 03/08/11 Pretty nice! Tons of room with the BDE mounts to stuff - Ash's Z 10:28:33 03/08/11 Nice, don't forget to pull those rags out. =) (n/m) - ChrisZTT(Sacto, CA) 11:15:30 03/08/11 Yeah,my son is belt sanding them today then reinstall . (n/m) - xteam300tt 11:48:20 03/08/11 Nice work... - Jim (Selin Design) 11:58:31 03/08/11 Thanx , I appreciate the thoughts and concerns . - xteam300tt 12:11:43 03/08/11 thanks for sharing! (n/m) - BoneZ 13:07:58 03/08/11 Nice fab work! (n/m) - KongZTT GT28RS MD 13:49:12 03/08/11 Nice job. Wanting to do same, but time is not available. (n/m) - Boosted1 20:24:36 03/08/11
Post a Followup	You cannot reply to this message because you are not logged in.