Subject	No (n/m)
Posted by	Bernie (NoVA) on March 08, 2011 at 10:07 AM
	This message has been viewed 102 times.
In Reply To	Are the injector spades even the same size? (n/m) posted by BigTDogg (MA) on March 07, 2011 at 10:03 AM
Message
Follow Ups	I was wondering how do you get the metal prongs outa the - 300zx_2+2 10:28:54 03/06/11 I just cut and soldered the new clips on my new EFI harness - KongZTT GT28RS MD 10:47:57 03/06/11 Same here. I just cut and soldered the new connectors. - ForceFedTT (SoCal) 15:12:46 03/06/11 Those aren't "de-pinnable" like coil pack connectors - CoHPhasor 13:10:26 03/06/11 actually they are.. it just takes some patience.. - KongZTT GT28RS MD 13:21:13 03/06/11 I figured that they were de-pinnable but I was starting to - 300zx_2+2 14:15:40 03/06/11 Are the injector spades even the same size? (n/m) - BigTDogg (MA) 10:03:35 03/07/11 I think they were.. they looked similar - KongZTT GT28RS MD 11:37:44 03/07/11 No (n/m) - Bernie (NoVA) 10:07:23 03/08/11 Right, so depinning is pointless (n/m) - BigTDogg (MA) 16:28:32 03/08/11 Cut & splice (n/m) - Bernie (NoVA) 10:07:52 03/08/11
Post a Followup	You cannot reply to this message because you are not logged in.