Subject	My solution to the 2.5" inlet pipes >>>
Posted by	xteam300tt on March 08, 2011 at 9:45 AM
	This message has been viewed 790 times.
Message	After speaking with Specialty Z , Z1 and Ash last week it was clear that nothing would be available for months . Ash was a pleasure to talk to and enlightened me on a few thoughts but I couldnt wait months for the pipes so heres what I did . A friend machined me some flanges and last night me and my son fab'd these up . I'm running a fmic so these inlet pipes will run into 3" acordian pipes that will be fab'd once in the Z and connected by a 3" to 2.5" 90 degree reducer coupler that will mount my maf's in the side mount position . We"ll see how that works , gotta be better than stock !
Follow Ups	My solution to the 2.5" inlet pipes >>> - xteam300tt 09:45:32 03/08/11 Pretty nice! Tons of room with the BDE mounts to stuff - Ash's Z 10:28:33 03/08/11 Nice, don't forget to pull those rags out. =) (n/m) - ChrisZTT(Sacto, CA) 11:15:30 03/08/11 Yeah,my son is belt sanding them today then reinstall . (n/m) - xteam300tt 11:48:20 03/08/11 Nice work... - Jim (Selin Design) 11:58:31 03/08/11 Thanx , I appreciate the thoughts and concerns . - xteam300tt 12:11:43 03/08/11 thanks for sharing! (n/m) - BoneZ 13:07:58 03/08/11 Nice fab work! (n/m) - KongZTT GT28RS MD 13:49:12 03/08/11 Nice job. Wanting to do same, but time is not available. (n/m) - Boosted1 20:24:36 03/08/11
Post a Followup	You cannot reply to this message because you are not logged in.