Subject	As Bernie suggested below - just get another used
Posted by	jzack on February 26, 2011 at 6:31 PM
	This message has been viewed 132 times.
In Reply To	Well, Ive done enough damage for today posted by blackomega on February 26, 2011 at 04:12 PM
Message	bracket. At some point in the future (no rush) - remove the t-belt cover on that side then replace the bracket. Just be aware that I've had those brackets put up a good fight -- they are held in place by 3 bolts as well as 2 locator pins on the back side of the bracket. The pins get stuck in place over the years. Best way I've found to get them undone is by whacking the bracket with a small rubber mallet - eventually it wiggles loose (but can take a bit of time)....
Follow Ups	Well, Ive done enough damage for today - blackomega 16:12:39 02/26/11 Get a bit extractor from lowes or an autoparts store! (n/m) - JonnyZ(SoCal) 16:24:30 02/26/11 The other 2 bolts will hold it fine. - Woody75 (Denver) 16:25:14 02/26/11 It should drive fine on one bolt but don't push it - Zarcasm(Hfd, CT) 16:34:13 02/26/11 Just replace the bracket - I have several available. (n/m) - Bernie (NoVA) 16:55:33 02/26/11 These dont need to be "TIGHT" Just good n snug >>> - xteam300tt 17:34:42 02/26/11 As Bernie suggested below - just get another used - jzack 18:31:51 02/26/11 1/8 in or smaller pilot drill, pb blaster soak. .. - ttz'in (NorCal) 07:50:42 02/27/11 I got a chrome one I can ship out tomorrow. (n/m) - BigTDogg (MA) 17:51:51 02/27/11
Post a Followup	You cannot reply to this message because you are not logged in.