Subject	I recently cut a crank in half and it appears that
Posted by	ztunerz on February 22, 2011 at 11:58 PM
	This message has been viewed 429 times.
In Reply To	I was wondering about that before.. the 1000hp breakage.. posted by KongZTT GT28RS MD on February 22, 2011 at 09:53 PM
Message	There is some form of heat / hardening treatment that goes down 1/4 of an inch in each of the main journals. Only true test would be to measure the hardness to see the difference. Harry Formerly yellowzxtt
Follow Ups	Stroker kits by PAECO Industries - RevTech 18:32:07 02/21/11 wow, almost 3600cc? (n/m) - blackomega 19:07:07 02/21/11 boom (n/m) - aliaZ 19:18:21 02/21/11 I'd give a few tick tick tick then boom..:-) (n/m) - slick007l 19:46:58 02/21/11 Don't - collegeboy 20:00:54 02/21/11 Welded cranks - Sure :) (n/m) - ztunerz 20:44:44 02/21/11 When it sounds to good to be true, it usually is. (n/m) - Timmay 22:17:54 02/21/11 The issue is the rewelded Crank.. - Carlos Ramirez 07:38:53 02/22/11 Re: The issue is the rewelded Crank.. - aliaZ 17:16:13 02/22/11 I was wondering about that before.. the 1000hp breakage.. - KongZTT GT28RS MD 21:53:44 02/22/11 I recently cut a crank in half and it appears that - ztunerz 23:58:46 02/22/11 they weren't running a harmonic balancer - aliaZ 12:04:52 02/23/11 ah yes.. - KongZTT GT28RS MD 14:40:48 02/23/11 I agree - Carlos Ramirez 08:30:30 02/23/11 Doesn't Collegeboy have Crowers setup? (n/m) - KongZTT GT28RS MD 14:42:32 02/23/11 I think he has Cosworth but I don't remember exactly (n/m) - Carlos Ramirez 21:26:15 02/23/11 Don't - ArubaDave 10:05:08 02/22/11 I talked to Devin a bit - Carlos Ramirez 13:57:08 02/22/11 I was helping put together a Z with one of thier kits. - Woody75 (Denver) 22:19:12 02/22/11 what a shame.. would be nice to see what would've happend (n/m) - KongZTT GT28RS MD 14:41:43 02/23/11
Post a Followup	You cannot reply to this message because you are not logged in.