| I have had to use soft hose and bring it up under the plenum alongside the injectors to get the best operating angle/bend. I toyed with the idea of crossing them over so my RH side PCV goes to my left hand side rocker cover and vice versa... Asked the question everywhere and no one could give me a reason not to - but that was when I was trying to use braided and the bends were going to be very very tight. There is a fuel rail leg directly opposite both points. I welded on -8 Bungs and tried a 90 and a 45 degree aero fitting and neither worked out so I had to go for the soft braided pipe and a straight AN connector. Not sure if these help matey but... here I was trying a couple of 180's - excuse the mess - it's a mock up session so.. 
So my recommendation is soft braided oil line coming in from the rear but underneath the plenum and up to the cover to connect. Hope that helps.
|
I have BDE and... - 
