Subject	Depends on if you have stock or Bronze bushings
Posted by	Joe@ZSpeed (Spddracer) on February 20, 2011 at 11:15 AM
	This message has been viewed 344 times.
In Reply To	Shifter bolt tightness vs shift quality. posted by aquariuscsm on February 20, 2011 at 10:03 AM
Message	If you are using stock bushings and sleeve you want it tight as the sleeve will prevent it from smashing the bushings and keeping you from overtighting it. With bronze bushings I just snug it up with a lock nut, Too tight and it will cause the shifter to drag on the bushings, Basically you just want zero clearance or just a tad but you don't want to be able to move it side to side. www.Zspeedperformance.com
Follow Ups	Shifter bolt tightness vs shift quality. - aquariuscsm 10:03:36 02/20/11 Snug is good but the real issue is deterioration of the - jzack 10:21:08 02/20/11 Depends on if you have stock or Bronze bushings - Joe@ZSpeed (Spddracer) 11:15:02 02/20/11 All the way tight, then back off 1/4-1/2 turn. (n/m) - Woody75 (Denver) 15:15:46 02/20/11 Stock bushings. - aquariuscsm 20:59:02 02/20/11
Post a Followup	You cannot reply to this message because you are not logged in.