Subject	Shifter bolt tightness vs shift quality.
Posted by	aquariuscsm on February 20, 2011 at 10:03 AM
	This message has been viewed 360 times.
Message	I searched Goolgle and here and read some info where having the shifter bolt (the bolt that holds the shifter to the shifter fork on the tranny) good and tight,not overtight,but snugged down (15 lbs torqued) will improve gear selection and shift quality. I have mine loose enough that I can move the bolt side to side,but of course it`s locked in place with a locking nut. Is it better for gear selection/shift quality to have it snugged down,therefore getting rid of any of the "slop" with having it loose?
Follow Ups	Shifter bolt tightness vs shift quality. - aquariuscsm 10:03:36 02/20/11 Snug is good but the real issue is deterioration of the - jzack 10:21:08 02/20/11 Depends on if you have stock or Bronze bushings - Joe@ZSpeed (Spddracer) 11:15:02 02/20/11 All the way tight, then back off 1/4-1/2 turn. (n/m) - Woody75 (Denver) 15:15:46 02/20/11 Stock bushings. - aquariuscsm 20:59:02 02/20/11
Post a Followup	You cannot reply to this message because you are not logged in.