Subject	Dual intake
Posted by	JMartz on February 17, 2011 at 7:08 PM
	This message has been viewed 447 times.
Message	I recently purchased the Selin translator and elbows as part of the group buy from SZ. I am in the process of doing the installation. After several hours and a number on test fits I cannot come up with a location to install the tranlator body using its supplied bracket. There is not a lot of slack on the connector cable. I'm about to wire tie it to the airbox snorkel. Any ideas would be welcome. Stand by for some pictures of the process. I will post them when I'm finally done.
Follow Ups	Dual intake - JMartz 19:08:59 02/17/11 it goes on the left edge where the stock airbox mounted (n/m) - Bernie (NoVA) 19:12:19 02/17/11 Like so - Bernie (NoVA) 19:22:59 02/17/11 Re: Dual intake - Seb@Specialty-Z 19:17:02 02/17/11 it's yellow but not my Z...I have allen head bolts ;-) - ZonaZ 19:29:42 02/17/11 Thanks that's my Z (n/m) - njz 19:30:03 02/17/11 thanks for the clear up guys. (n/m) - Seb@Specialty-Z 19:37:38 02/17/11 Re: thanks for the clear up guys. - njz 20:15:24 02/17/11 Re: Re: thanks for the clear up guys. - Seb@Specialty-Z 22:47:22 02/17/11 Re: Re: Re: thanks for the clear up guys. - njz 07:50:30 02/18/11 Installed: - Ziceman(East TN) 19:25:13 02/17/11 How does the filter bracket attach? - ZXoltan 20:00:45 02/17/11 The "T" bracket mounts to the underside of the - Jim (Selin Design) 20:12:53 02/17/11 Thanks. Have to look again when the fascia is removed. (n/m) - ZXoltan 21:13:24 02/17/11 The above photos are correct... - Jim (Selin Design) 20:08:11 02/17/11 you should feel horrible! :) (n/m) - KongZTT GT28RS MD 20:51:19 02/17/11
Post a Followup	You cannot reply to this message because you are not logged in.