Subject	Here's what I think
Posted by	cherryz on February 12, 2011 at 8:44 PM
	This message has been viewed 407 times.
In Reply To	Am I correct then that the two round solder joints that are posted by PiotrC70 on February 12, 2011 at 05:26 PM
Message	The black line is not a burnt trace, it is a crack that separated a voltage pin from a voltage plane. The round solder joint to the left of the G in 'GND' is OK. The round solder joint directly below the N in 'GND' has been broken away from a voltage plane, and should NOT be connected to GND. Instead, it should be jumpered to one of the two pins above C7. C7 is a cap that decouples across a voltage. If you follow the thick trace around the top of the board, it goes to the opposite side of C7 from the crack. It would not make sense for the other side of C7 to also be a ground, it must be some voltage that the crack separated from that one round solder joint. Would have to look at both sides of the board to be sure. My opinion, use advice at your own risk.
Follow Ups	Calling on gauge cluster experts. - PiotrC70 16:22:38 02/12/11 That's the typical place the traces start to break down. - DVDBURN (MD) 17:10:44 02/12/11 Am I correct then that the two round solder joints that are - PiotrC70 17:26:39 02/12/11 Here's what I think - cherryz 20:44:13 02/12/11 That looks to be exactly right. - CoHPhasor 21:10:22 02/12/11 Incorrect! - DVDBURN (MD) 11:48:10 02/13/11 Yes, dark green area is misleading. - cherryz 19:10:13 02/13/11 Yep. The dark area is the circuit trace going bad. - DVDBURN (MD) 01:27:28 02/14/11 See my post below. - DVDBURN (MD) 11:49:25 02/13/11
Post a Followup	You cannot reply to this message because you are not logged in.