Subject	Calling on gauge cluster experts.
Posted by	PiotrC70 on February 12, 2011 at 4:22 PM
	This message has been viewed 881 times.
Message	My speedometer doesn't work at all and it is the only gauge which doesn't work. I've already swapped out the transmission speed sensor with a known working one and was left with taking apart the cluster. The pics below are the back of the speedometer and I'm wondering if it's fixable with new soldered jumper wires to ground, or if I'm just effed. The resistors, capacitors, etc, all APPEAR good with no swelling or burn marks. The upper right area of the pictures are the only thing in question. The upper right ground screw was a little oxidized and will clean that before reassembling. Thanks! 1993 TT. R.I.P. 09.15.2010
Follow Ups	Calling on gauge cluster experts. - PiotrC70 16:22:38 02/12/11 That's the typical place the traces start to break down. - DVDBURN (MD) 17:10:44 02/12/11 Am I correct then that the two round solder joints that are - PiotrC70 17:26:39 02/12/11 Here's what I think - cherryz 20:44:13 02/12/11 That looks to be exactly right. - CoHPhasor 21:10:22 02/12/11 Incorrect! - DVDBURN (MD) 11:48:10 02/13/11 Yes, dark green area is misleading. - cherryz 19:10:13 02/13/11 Yep. The dark area is the circuit trace going bad. - DVDBURN (MD) 01:27:28 02/14/11 See my post below. - DVDBURN (MD) 11:49:25 02/13/11
Post a Followup	You cannot reply to this message because you are not logged in.