Subject	Re: What are you having done to the heads?
Posted by	Zarcasm(Hfd, CT) on February 05, 2011 at 7:26 PM
	This message has been viewed 205 times.
In Reply To	What are you having done to the heads? (n/m) posted by Wright (Ca) on February 05, 2011 at 06:21 PM
Message	Install JWT CAS Drive Gear 3 angle valve job Defective valves replaced if necessary Resurface Pressure test New valve stem seals Stem height check Valve guides check Clean and/or replace hydraulic lifters Just looking to bring back stock performance. I'm doing this mostly as a last ditch effort at fixing a hesitation issue that I've been hunting down for the last two years. Thoughts? Zarcasm(Hfd, CT) view My Technical posts (click here) view My General posts (click here)
Follow Ups	Winter Project Update: EGR delete and Refurbish Heads - Zarcasm(Hfd, CT) 16:27:37 02/05/11 Looks good! Knock sensor and harness for starters... (n/m) - ZiNnYc 16:33:32 02/05/11 So much easier to just pull the engine to do that. (n/m) - Halo TTZ 17:18:28 02/05/11 maybe so... but I don't have the equip. or room. (n/m) - Zarcasm(Hfd, CT) 17:46:42 02/05/11 well i can understand that. - Halo TTZ 17:57:39 02/05/11 Congrats Taylor. - Agner.S(CT) 17:26:30 02/05/11 What are you having done to the heads? (n/m) - Wright (Ca) 18:21:46 02/05/11 Re: What are you having done to the heads? - Zarcasm(Hfd, CT) 19:26:09 02/05/11 Pull it, Ring it and throw some bearings in it. - Joe@ZSpeed (Spddracer) 00:55:06 02/06/11 I remember those same words... - ZXRider 02:41:12 02/06/11 Meaning pull engine and put new rings and bearings in? - Zarcasm(Hfd, CT) 09:02:33 02/06/11 Ya, if you don't have the space/time - ZXRider 11:13:31 02/06/11 Are you going to have enough clearance to properly torque - Forced1(NYC) 02:04:23 02/06/11 Actually there's more than enough clearance for that - Zarcasm(Hfd, CT) 08:57:34 02/06/11 Nice. Make sure you change your knock sensor and - ZXRider 02:45:22 02/06/11 Why is replacing the knock sensor and harness important? - Zarcasm(Hfd, CT) 09:05:57 02/06/11 Because of the heat the knock sensor harness - ZXRider 11:11:22 02/06/11 They both go bad from age, If they don't work correct - Joe@ZSpeed (Spddracer) 19:08:34 02/06/11
Post a Followup	You cannot reply to this message because you are not logged in.