Subject	So much easier to just pull the engine to do that. (n/m)
Posted by	Halo TTZ on February 05, 2011 at 5:18 PM
	This message has been viewed 170 times.
In Reply To	Winter Project Update: EGR delete and Refurbish Heads posted by Zarcasm(Hfd, CT) on February 05, 2011 at 04:27 PM
Message
Follow Ups	Winter Project Update: EGR delete and Refurbish Heads - Zarcasm(Hfd, CT) 16:27:37 02/05/11 Looks good! Knock sensor and harness for starters... (n/m) - ZiNnYc 16:33:32 02/05/11 So much easier to just pull the engine to do that. (n/m) - Halo TTZ 17:18:28 02/05/11 maybe so... but I don't have the equip. or room. (n/m) - Zarcasm(Hfd, CT) 17:46:42 02/05/11 well i can understand that. - Halo TTZ 17:57:39 02/05/11 Congrats Taylor. - Agner.S(CT) 17:26:30 02/05/11 What are you having done to the heads? (n/m) - Wright (Ca) 18:21:46 02/05/11 Re: What are you having done to the heads? - Zarcasm(Hfd, CT) 19:26:09 02/05/11 Pull it, Ring it and throw some bearings in it. - Joe@ZSpeed (Spddracer) 00:55:06 02/06/11 I remember those same words... - ZXRider 02:41:12 02/06/11 Meaning pull engine and put new rings and bearings in? - Zarcasm(Hfd, CT) 09:02:33 02/06/11 Ya, if you don't have the space/time - ZXRider 11:13:31 02/06/11 Are you going to have enough clearance to properly torque - Forced1(NYC) 02:04:23 02/06/11 Actually there's more than enough clearance for that - Zarcasm(Hfd, CT) 08:57:34 02/06/11 Nice. Make sure you change your knock sensor and - ZXRider 02:45:22 02/06/11 Why is replacing the knock sensor and harness important? - Zarcasm(Hfd, CT) 09:05:57 02/06/11 Because of the heat the knock sensor harness - ZXRider 11:11:22 02/06/11 They both go bad from age, If they don't work correct - Joe@ZSpeed (Spddracer) 19:08:34 02/06/11
Post a Followup	You cannot reply to this message because you are not logged in.