Subject	Little progress on KA-T Z
Posted by	fairZ on January 15, 2011 at 7:30 PM
	This message has been viewed 758 times.
Message	motor is bolted in ,trans and driveshaft are installed and engine is lined up and level . Started on ic piping and exhaust . 3in downpipe to a stillen cat back exhaust .dual 2.5in . tomorrow I will be finishing up the exhaust and ic piping ,then will move to wiring . few pics
Follow Ups	Little progress on KA-T Z - fairZ 19:30:53 01/15/11 The nose panel just blinded me (n/m) - awesom-o 21:49:16 01/15/11 Looking better. Figure out your hood clearance issue yet? (n/m) - Wright (Ca) 22:33:32 01/15/11 Re: Looking better. Figure out your hood clearance issue yet? - fairZ 22:52:12 01/15/11 Good luck w. bonding that to a factory aluminum hood. (n/m) - Bernie (NoVA) 23:10:22 01/15/11 why not just get some aluminum and make the hump? - TeddyZ(SFC) 05:53:33 01/16/11 Instead of altering the hood you could make an adapter - Wright (Ca) 11:13:45 01/16/11 2nd that, probably cheaper than altering hood too - Dane (Houston) 13:33:26 01/16/11 Re: 2nd that, probably cheaper than altering hood too - fairZ 14:48:16 01/16/11 Re: Re: 2nd that, probably cheaper than altering hood too - Dane (Houston) 16:07:42 01/16/11 Re: 2nd that, probably cheaper than altering hood too - fairZ 14:49:01 01/16/11
Post a Followup	You cannot reply to this message because you are not logged in.