Subject	Ashs IC piping has ovaled pipes near the radiator
Posted by	ZiNnYc on January 01, 2011 at 12:46 PM
	This message has been viewed 138 times.
In Reply To	My New Years' Shopping List - need input posted by JGZ32 on December 31, 2010 at 11:10 PM
Message	to allow for smoother R&R. Also, instead of a Stillen oil cooler and Koyo radiator, why not get the SPL radiator with built in cooler? Since youre getting a whole mass of stuff from SPL, it only makes sense. If you dont extrude hone your plenum and match the lower, I dont think the Z1 TB is going to do much for you, and can put that money towards the radiator. if money is no issue, then get em of course. Fab up some inconel heat shields for the turbo and manifolds. Adjustable intake and exhaust cams? Braking system? Gonna go plenty fast, but how are you stopping? FUCAs?
Follow Ups	My New Years' Shopping List - need input - JGZ32 23:10:17 12/31/10 Sounds like a kickass build - MrOzzie5183 00:11:55 01/01/11 Re: Sounds like a kickass build - JGZ32 11:46:38 01/01/11 If you can, add the MS turbo inlet pipes and SZ's - Mr.Stacy 09:25:45 01/01/11 Re: If you can, add the MS turbo inlet pipes and SZ's - JGZ32 11:47:55 01/01/11 I need your job (n/m) - pearlzed(toronto) 11:27:28 01/01/11 Ashs IC piping has ovaled pipes near the radiator - ZiNnYc 12:46:21 01/01/11 need a boost controller, bde intake gears (n/m) - BoneZ 13:47:46 01/01/11 How about some head work: 1mm oversize valves and - SirpriZ 14:00:31 01/01/11 already part of the ipp long-block number 5? - vulcanrush 16:15:21 01/01/11 Hi Trinh, Oops you're right. Take care, Mark (n/m) - SirpriZ 18:00:22 01/01/11 if you were working instead of slacking off - vulcanrush 22:37:58 01/01/11 Yes Sir! (n/m) - SirpriZ 17:51:55 01/03/11
Post a Followup	You cannot reply to this message because you are not logged in.