Subject	i did mine with no parts
Posted by	KasbeKZ(VA) on December 19, 2010 at 11:18 PM
	This message has been viewed 169 times.
In Reply To	Rebuilding the Power Steering Pump posted by ZXRider on December 19, 2010 at 09:45 PM
Message	not to say that's recommended, but it worked. my big tip for the rebuild is to be careful when you put that first round piece back in. look for the slots in the side that the alignment pins go into. people often (me included) don't notice the slots and just stick it in, then the face won't go back on all the way.
Follow Ups	Rebuilding the Power Steering Pump - ZXRider 21:45:56 12/19/10 Simple proces. I believe the shaft and bearing are NLA for - Wright (Ca) 22:08:07 12/19/10 Yes it is a 94 TT so the pump is a single chamber - ZXRider 23:04:03 12/19/10 The old bearing on the shaft was a little tight, - whip 23:13:05 12/19/10 This is no writeup, but it gives you a general idea... - whip 22:57:44 12/19/10 Thanks for the pictures - ZXRider 23:02:21 12/19/10 I ordered the shaft as well. Z1 has the entire Kit. - whip 23:06:05 12/19/10 Got it. Thank you. - ZXRider 23:13:39 12/19/10 Another of the hollow pump: - whip 23:03:29 12/19/10 Did you still need a pivot bolt or where you able to get 1? (n/m) - Bernie (NoVA) 12:10:52 12/20/10 Ordered one from Courtesy, took 2 weeks but it showed up. (n/m) - whip 19:14:53 12/20/10 Cool - I picked up 3 yesterday (n/m) - Bernie (NoVA) 20:50:41 12/20/10 These are the parts I got to rebuild mine; - jschrauwen 23:16:16 12/19/10 i did mine with no parts - KasbeKZ(VA) 23:18:57 12/19/10 also, - KasbeKZ(VA) 23:50:54 12/19/10
Post a Followup	You cannot reply to this message because you are not logged in.